2

Remodeling a Home Built Before 1920 in West Michigan | Amber Valley Construction
Amber Valley Construction
On Budget. On Time. Guaranteed.

Era Remodeling Guide · Before 1920

Remodeling a Home Built Before 1920: What West Michigan Homeowners Need to Know

A home built before 1920 was wired, plumbed, and framed for a way of living that no longer exists.

A home built before 1920 was wired, plumbed, and framed for a way of living that no longer exists. The wiring carried a few light bulbs. The plumbing served one bathroom. The framing was never meant to be opened up or carried different loads. Everything still in original condition is decades past the lifespan it was designed for. That does not make the house a bad investment, because these homes are often framed from old-growth lumber that outperforms anything at the yard today, but it means a remodel touches several aging systems at once, and the cost lives in that overlap.

Is it worth remodeling a 100-year-old house?

Usually yes, if you go in understanding what you are buying. The bones of a pre-1920 home, the framing, the masonry, the millwork, are frequently superior to new construction, and the character and the location cannot be reproduced. The work is not about fixing a structure that is failing. It is about replacing the systems inside a sound structure, all of which have aged out together. The mistake is budgeting for the kitchen you can see and not for the wiring, plumbing, and abatement the kitchen will force you to touch.

What kind of wiring does a pre-1920 home have?

Almost always knob-and-tube, which was the standard from roughly 1880 to 1940. It has no ground wire, it was sized for a fraction of a modern home's electrical load, and it cannot safely be in contact with insulation, because the wires were designed to shed heat in open air. Many insurers will not write a policy on an active knob-and-tube system, or they charge a premium for it. The practical issue on a remodel is that once you open walls and a city inspector signs off on new work, the old wiring in the area usually has to be brought up to code. A kitchen remodel can turn into a partial or full rewire, and that needs to be in the budget from the start, not discovered at demolition.

What about the plumbing in a pre-1920 home?

Two materials, both at the end of their lives. Galvanized steel supply pipe lasts forty to sixty years and rusts from the inside out, which restricts flow and discolors water long before it leaks, so any original galvanized in a pre-1920 home is well past that window. Cast iron drain lines last fifty to a hundred years and are at or beyond the top of that range. Neither is a repair item at this age. Plan for them as system replacements, and expect that getting at them means opening walls and floors that the cosmetic scope would not otherwise touch.

Do I have to deal with lead paint and asbestos?

Yes, and it is not optional. The EPA estimates that roughly 87 percent of homes built before 1940 contain lead-based paint, which was banned for residential use in 1978. Federal law requires that renovation work disturbing painted surfaces in a pre-1978 home be done by an EPA-certified renovator following lead-safe practices. Asbestos shows up in plaster, pipe and duct wrap, and other materials from this era and stays inert until it is disturbed, which is exactly what demolition does. Identifying and handling both before work starts is a regulated step, and the cost of doing it right belongs in the budget rather than as a surprise mid-project.

What is different about balloon framing and plaster walls?

Pre-1920 homes are typically balloon-framed, meaning the wall studs run continuously from the foundation to the roof with no horizontal blocking between floors. That creates open vertical cavities the full height of the house. It is a known fire-spread path, it complicates insulation and any structural modification, and opening a wall for a remodel often means adding fire blocking and engineering that a newer home would not need. The plaster-and-lath walls cannot be demolished casually either. They are heavier, messier, and more labor-intensive to remove and patch than drywall, and that labor is real money on a whole-home project.

What does this mean for my budget?

The defining feature of a pre-1920 remodel is that the systems overlap. You cannot rewire without opening walls, you cannot get at the old plumbing without opening more, you cannot open any of it without triggering abatement, and the plaster makes every one of those steps slower. A project priced as if it were a cosmetic update will run over, because the era of the house turns one visible job into four connected ones. The right way to price it is as a coordinated systems replacement inside a sound structure, with the wiring, plumbing, abatement, and finish work planned together from the beginning.

We do not treat an old house as a problem to be managed. We treat it as a sound structure whose systems have aged out together, and we price the work that way, every connected piece accounted for before you sign, not discovered after demolition. That is the entire point of our fixed-price model. On a home this old, the surprises are predictable if someone takes the time to look for them first.

If you have drawings or a contractor's bid for a pre-1920 home, a Project Risk Snapshot™ will read them against what we know is behind the walls in homes of this era and show you where the bid is thin before you commit.

Zero Change Order Guarantee
Finish-By Guarantee
Fixed-Price Contract

See where your money is exposed before you commit

If you have plans or a contractor's bid in hand, a Project Risk Snapshot™ reads them against the realities of your home's era and shows you where the budget is thin.

Sources
  1. Knob-and-tube wiring standard c.1880–1940, ungrounded, must not contact insulation: InterNACHI, Center for Energy and Environment.
  2. Galvanized steel supply pipe lifespan 40–60 yrs (rusts internally); cast iron drain lifespan 50–100 yrs: howtolookatahouse.com, plumbing-industry references.
  3. About 87% of pre-1940 homes contain lead paint; banned 1978; EPA RRP rule requires certified renovator for pre-1978 work: EPA, Indoor Science.
  4. Balloon framing: continuous studs foundation-to-roof, no fire blocking, higher renovation cost: The Craftsman Blog, CanaStruct.